« Fun with Vendor FUD Episode #1 | Main | VMware Partner Exchange 2010 from where I sat »

February 13, 2010


Feed You can follow this conversation by subscribing to the comment feed for this post.

Itzik Reich

please make sure to set up the IP + username that will be used to query the SE appliance, so for an example, if you are using the SE for EMC Storage Viewer, you will install solution enabler (client) on the vCenter server and you will configure the SE appliancen NetHost to have the IP of the vCenter server And the username that is currently logged on to the vCenter (i normally configure all the sysadmins)


Hi guru,
i am from storage domain. last night i downloaded the vapp for EMC solution enabler & tried to run from vmware workstation 6.5 no luck.

can you please tell me can i run this vapp from vmware workstation ..?


Hi Chad,

will Solutions Enable also work with CX3?



Verify your Comment

Previewing your Comment

This is only a preview. Your comment has not yet been posted.

Your comment could not be posted. Error type:
Your comment has been saved. Comments are moderated and will not appear until approved by the author. Post another comment

The letters and numbers you entered did not match the image. Please try again.

As a final step before posting your comment, enter the letters and numbers you see in the image below. This prevents automated programs from posting comments.

Having trouble reading this image? View an alternate.


Post a comment

Comments are moderated, and will not appear until the author has approved them.

Your Information

(Name and email address are required. Email address will not be displayed with the comment.)

  • BlogWithIntegrity.com


  • The opinions expressed here are my personal opinions. Content published here is not read or approved in advance by Dell Technologies and does not necessarily reflect the views and opinions of Dell Technologies or any part of Dell Technologies. This is my blog, it is not an Dell Technologies blog.